diff --git a/printer.cfg b/printer.cfg
index e35869c..68192a6 100644
--- a/printer.cfg
+++ b/printer.cfg
@@ -301,7 +301,7 @@ gcode:
 	;MQTT_START
 	M117 Heating...;
 	#;M221 S{if layer_height<0.075}100{else}95{endif} ; Set flow
-	M104 S{ params.TOOL_TEMP } ; set extruder temp
+	M104 S170 ; set extruder temp
 	M140 S{ params.BED_TEMP } ; set bed temp
 	#G1 Z20 ; this is a good start heating position
 
@@ -317,6 +317,11 @@ gcode:
 	G28;
 	G29;
 
+	G1 X5.0 Y5.0 F7200 ; Move to a position in the left front of the bed
+	G1 Z0.6; Move nozzle above 0.6 mm of the bed
+	
+	M104 S{ params.TOOL_TEMP } ; set extruder temp
+	
 	; Prepare nozzle
 	G92 E0 ; Set extrusion distance to 0
 	G92 E0 ; Set extrusion distance to 0
@@ -324,10 +329,6 @@ gcode:
 	G92 E0 ; Set extrusion distance to 0
 	G90;
 
-	; You may want to adjust the X and Y here so the nozzle is really above the bed!
-	G1 X5.0 Y5.0 F7200 ; Move to a position in the left front of the bed
-	G1 Z0.6; Move nozzle above 0.6 mm of the bed
-
 	G91 ; Use relative mode
 
 	; Make some jerky zick-zack move at the beginning